|
Beer Tap Information
 Highest Standards in Keg Couplers for all situations a bar and tavern operator or individual may have. We will also supply all households with the same fine couplers we sell to the commercial taverns.
The draught beer keg coupler or valve allows the gas (CO2, Nitrogen, Air or Blended beer & stout gas) to enter the keg and the kegs beverage (beer, ale, stout, porter, wine, soda, alt etc.) to exit the beer keg.
The gas line from the primary or secondary regulator connects to the 5/16" tailpiece on the coupler.
The beverage exits via tailpiece which is connected to a hose going to the beer faucet's shank tailpiece. This is normally a 3/16" tail piece in residential and direct draw applications and is the tailpiece supplied with all our coupler assemblies.
A 5/16" or 3/8" tailpiece is used in most long & short draw commercial applications. In all but the Perlick Low Profile the beverage exits the coupler from the top while the Perlick has a built in 3/16" tail piece on the side opposite the 5/16" gas nipple.
All keg couplers come with a 5/16" gas hose tail piece on the side. Our the assemblies come with a 3/16" tail piece. Stainless Steel tail pieces are supplied with all s/s keg couplers as well as the beer nuts and washers as applicable.
Some couplers can be supplied with different color handles to aid bar managers in distinguishing beers in a large cold room.
Check Tap by Brewery for the correct beer coupler.
Click on the Series keg valve you need and see the widest selection of parts on the Internet.
 Quality: All the couplers we sell are selected from the finest US manufacturers for use in the application they are listed with.
- Safety: All couplers are all equipped with an integral safety relief device which prevents a keg from exceeding the recommended working pressure if there is a regulator failure.
- Efficiency: These couplers are designed for maximum flow in either single or series keg dispensing(except Perlick Low Profile which is for very special applications).
- Reliability: Unlike the couplers made for home use these are designed and manufactured to meet the rough and tumble handling in commercial bars and taverns.
- If kept lubricated with Probe and tap Lubricant they will provide years of rough service.
- These keg coupler valves are able to tap all "D" 1/6, 1/5. 1/4, and 1/2 barrels.
|
Copyright © 1981 - 2009 Kegman LLC
This page generated by a
Crossfire Engineering
automated PERL program on Wed, Sep 23, 2009 at 06:54:27.
|
|
