|
|
Keg Coupler
Selection Page
 Highest
Standards in Keg Couplers
for all situations a bar and
tavern operator or individual
may have. We will also supply
all households with the same
fine couplers we sell to the
commercial taverns.
The
draught beer keg coupler or
valve allows the gas (CO2,
Nitrogen, Air or Blended beer &
stout gas) to enter the keg and
the kegs beverage (beer, ale,
stout, porter, wine, soda, alt
etc.) to exit the beer keg.
The
gas line from the primary or
secondary regulator connects to
the 5/16" tailpiece on the
coupler.
The
beverage exits via tailpiece
which is connected to a hose
going to the beer faucet's shank
tailpiece. This is normally a
3/16" tail piece in residential
and direct draw applications and
is the tailpiece supplied with
all our coupler assemblies.
A
5/16" or 3/8" tailpiece is used
in most long & short draw
commercial applications. In all
but the Perlick Low Profile the
beverage exits the coupler from
the top while the Perlick has a
built in 3/16" tail piece on the
side opposite the 5/16" gas
nipple.
All
keg couplers come with a 5/16"
gas hose tail piece on the side.
Our the assemblies come with a
3/16" tail piece. Stainless
Steel tail pieces are supplied
with all s/s keg couplers as
well as the beer nuts and
washers as applicable.
We
have specific couplers designed
for both beer and wine kegs.
Beer kegs can use any of the
couplers but all USA commercial
establishments are now required
to use stainless steel for the
lower pH of beer, wine and
cider. Cider and wine requires
either a plastic probe coupler
or a 304 stainless steel (S/S)
probe coupler.
Some
couplers can be supplied with
different color handles to aid
bar managers in distinguishing
beers in a large cold room.
Check
Tap by Brewery for the
correct beer coupler.
Click on the Series keg valve
you need and see the widest
selection of parts on the
Internet.
-
 Quality:
All the couplers we sell are
selected from the finest US
manufacturers for use in the
application they are listed
with.
-
Safety:
All couplers are all
equipped with an integral
safety relief device which
prevents a keg from
exceeding the recommended
working pressure if there is
a regulator failure.
-
Efficiency:
These couplers are designed
for maximum flow in either
single or series keg
dispensing(except Perlick
Low Profile which is for
very special applications).
-
Reliability:
Unlike the couplers made for
home use these are designed
and manufactured to meet the
rough and tumble handling in
commercial bars and taverns.
-
If
kept lubricated with
Probe and tap Lubricant
they will provide years of
rough service.
-
These
keg coupler valves are able
to tap all "D" 1/6, 1/5.
1/4, and 1/2 barrels.
|
|
|
The System "D" for most US, Canadian & Mexican
beers, wines & ales such as Abita Brewing,
Maudite, Acme Brewing, Miami Trail Brewing,
Alexander Keith, Michael Shea's, Anderson Valley
Brewing, Michelob, Bad Frog, Michelob Light,
Bayhawk, Michelob Speciality, Black Dog,
Mickey's, Blanche de Chambly, Middle Ages, Blue
Moon, Miller, Breckenridge, Miller Genuine
Draft, Brooklyn Brewery, Miller Lite, Bruin Pale
Ale, Milwaukee's Best, Bud Ice, Modelo, Bud
Light, Molson, Budweiser, Moosehead, Busch,
Natural Ice, Carlsburg, Natural Light, Castle
Maine, New Amsterdam, Celis, New Zeland
Steinlager, Cider Jack, Nor'Wester, Columbia
Brewing, North Coast Brewing, Coors, O'Doul's,
Coors Light, Old Milwaukee, Corona, Old Vienna,
Deschutes Black Butte, Pete's Wicked Ale, Devil
Mountain, Porter & Summerfest, Dos Equis,
Portland Brewing Co., Eel River Brewing, Pyramid
Ale, Ellicottville, Razors Edge, Flying Dog, Red
Ale, Foster's, Red Dog, Full Sail, Red Hook,
Genesee, Red Wolf, Goose Island, Rogue Brewing,
Gordon Biersch, Rolling Rock, Grant's,
Rouge-Mogal, Green Mountain Cidery, Samuel
Adams, Hamms, Saxer Brewing, Henry Weinhard's,
Schmitt's, High Falls, Shiner Bock, Holy Cow
Red, Shipyard, Hornsby's, Sierra Nevada, Hudson
Valley, Sleemans, Humboldt Brewing, Southpaw,
Ice House, Spanish Peaks Black Dog, Killarney,
Starr Hill Brewery, Killian's Red, Steinlager,
Kirin, Strohs, Kokanee, Tecate, Labatt's, Thomas
Kemper, Leinenkugel, Trois Pistoles, Little
Kings, Unibroue, Lost Coast Brewery, Wasatch,
Lowenbrau (US only), Weidmar, Mad River Brewing,
Weinhard's, Whitbread Ale, Widmer, Wood Chuck,
Wyder's, Yuengling and Zebra. |
The System "S" for most European beers & ales
such as Amstel, Amstel Light, Becks , Belhaven ,
Belle-Vue, Bemish, Boddingtons, Cantillon Rose
(Belgium), De Koninck Ale (Belgium), Delirium
Tremens (Belgium), Dortmunder Union, Double
Diamond , Hahn, Heineken , John Courage,
Lindeman's, Lion Nathan , Lowenbrau (Import),
Maredsous Abbey Ale (Belgium) , Marston's
Pedigree, McEwan's , Moretti, Murphy's Irish
Stout & Red, Pilsner Urquell, Piraat, Scottish &
Newcastle , St. Pauli Girl , Stella Artois,
Strongbow Cider, Tetley's , Tooheys, Tucher, Van
Steenberge, Wood Pecker Cider & Woodpecker
Cider. |
The System "G" for Abbot Ale, Anchor Liberty
Ale, Anchor Porter, Anchor Steam, Bass Pale Ale,
Blackthorne Cider, Boddington, Caffrey's,
Fuller's ESB, Fuller's London Pride, Grolsch,
Old Speckeled Hen, Rouge, Scottish Tennents, Sir
Perry William's, Watney's, Young's, Young's
Chocolate Stout, Young's Oatmeal Stout, Young's
Ram Rod Bitter, Young's Special London Ale and
other English Ales & Bitters. |
The System "U" For Irish beers, stouts & ales
like Abby White, Guinness, Harp, Kilkenny,
Leffe, Magners, Smithwicks Ale and other Irish
single valve kegs |
The System "A" for German biers alts, lagers and
bocks like Ayinger, Bitburger, Erdinger Hefetrub
Weisse, Fischer, Franziskaner Hefe-Weisse,
Hacker-Pschorr Weisse, Hoegaarden White,
Isenbeck, Krombacher, Kronenbourg 1664,
Paulaner, Spaten, Staropramen, Victoria Bitter
and Warsteiner |
The System "M" for German biers alts, lagers and
bocks like Aventinus, Einbecker, Schneider &
Veltins |
The System "HS" for Older american beers and
wines such as Iron City, Ithaca, JW Dundee Honey
Brown, McSorley's, Papst - Check, Schaeffer,
Schlitz & Strohs |
Check
Tap by Brewery for the correct beer tap to
use with which brewery kegs.
See
Tap Accessories and
BeerStuff for Connector parts and
accessories
See
soda.htm for soda keg connector
Return to
Top of page.
|
We
are not responsible for typographical errors in
prices or descriptions. Pictures may not
correctly represent color or form.
Absolutely
no returns after 30 days for any reason. Orders
canceled within three days of invoice date may
be given a full refund. Items returned after 3
days will be given a store credit less a 30%
restocking fee and no cash refund will be
offered.
Only
items that are not a
SPECIAL ORDER items are eligible for
return and must be in new and unused condition.
No special order items may be returned for any
reason other than manufacturing defect - be sure
before you order it.
Prices
may change without notice due to economic
conditions. You must be over 18 years of age to
order from the KegMan. All orders without an
open account will have a 4 percent handling
charge on all items plus shipping, insurance and
surcharges. Shipping and handling charges are
never refundable.
Copyright © 1996 - 2007
Kegman
|
|
|
